Friday, 11 November 2011

Gilded Owls

Today's card is something new to me and I love it!

For this card I used....
Blue Eazi Score board and tool
 Dreamweaver pair of Owls stencil,
Pearlescent embossing paste,
Copper Thunder gilding flakes
MATT Black and Tan coloured cardstock
Copper pearl cardstock
Martha Stewart branch punch
Little Claires circular sentiment
Brown organza ribbon
Papermania shimmer chalk
Crafters Companion Spray & Shine
Double sided tape, PVA glue, low tack tape, quickie glue pen,
A paper trimmer
and a selection of contrasting pearls.



The first job was to attach the stencil to my black cardstock with low tack tape - I took most of the tack away so it wouldn't mark the black card - this is done by pressing the tape to clothing and pulling off several times.

Once attached I used the palette knife to completely cover the owls then scrapped away the excess paste and put it back in the pot.

Carefully I removed the low tack tape and discarded it - then put the owls to one side to dry completely

Next stage was to cut the black cardstock down to 15cms wide and scoring to create an easel card - that was line 7 A4 half fold and line 4 A4 gate fold

I measured a strip of matt tan cardstock to approx 2"  wide by 5.25" (5cms x 13cms) long - and punched along one long edge then turned over and matched up as I punched the other edge.

A piece of dark brown organza ribbon was wrapped around this punched strip and secured behind. A length of foam tape was attached to the back and then placed on the base of card to form the stopper.

I used a die cut circular sentiment from Little Claires that also featured an Owl - coloured it with Papermania shimmer chalk then sprayed lightly with Crafters Companion spray & shine to seal it, this was added to the centre of my punched strip with foam pads.

Using the same matt tan cardstock I measured a piece of card approx 5"  x 4" (12.5cms x 10cms) and punched one edge using the branch punch again.

Matted to this was a piece of copper pearl 4.5" x 3.25" (11.5cms x 8cms) then matt black 4.25" x 3" (11cms x 7.5cms) copper 4" x 3" (10cms x 7.5cms)

Once the embossing paste was dry completely ( around 4 hours I think I left it) I repositioned the stencil and used a good quality PVA glue to cover the owls - removed the stencil then completely covered the design with copper thunder gilding flakes and pressed firmly all over the design so as not to leave any white showing - then tapped the card to remove the excess and set aside to dry again

Once the PVA had dried I brushed away any loose bits of gilding then cut the topper down to fit onto the last matted piece of copper card - so approx 3.8" x 2.8" (9.5cms x 7cms) and attached centrally using double sided tape

All that was left was to add my pearls - I used a dark brown in the 4 corners of the owls topper and brown - beige - tan in the top left edge and bottom right edge of the punched matt tan cardstock

On the easel base I used 3 copper coloured pearls along the front edge at the left and the right to finish.

I do hope you like the card and that my instructions have proved useful!

Please note all measurements are approx.

Wednesday, 9 November 2011

Poinsettia

This card is another taken from Ella Designs 12 Cards For Christmas cd

The poinsettia is a stunning image and a real delight to work with

I decided to use a scallop edged card from Craft Work Cards

The main base image was added centrally to the card and then I made a start on the oh so easy to cut out decoupage



I built the design taking care to shape the top most layers to define the shape of the petals....

I wasnt sure what to use for decoration then spotted the last few Glitterations Sticky Gold dots which worked a treat!

I added a small gold glitter dot to each of the scallops down the right hand side and across the decorative panel across the centre of the card

4 larger dots were added to the 4 outer corners and then gold stickles was dabbed around the centre of each poinsettia to complete this lovely tradional christmas card

Thank you for your time

Gift Wallet Card

Hello again - bet you thought I had given up making cards didnt you?

Sorry - life just gets in the way at times....

So here we are - I have lots of new cards to share with you so lets hope time doesnt run away with me again....

This is a lovely card and gift in one really as it has a lovely pouch in which you can slip a gift voucher, gift card or even money

It is taken from a wonderful new cd I have by Ella Designs - called

12 cards of Christmas


However as you can see in this card - some can be adapted for general use

Everything is so easy on this cd - I simply chose the complete 3d card option which offered 2 pages of printing - and really easy to follow instructions on how to make the card up too!

I had to cut my a4 card down to measure 13cms x 29.7cms - that left a strip of waste card which then was cut to 8cms x13cms leaving just a small amount of waste

The scoring is all done using the Eazi Score Blue Board - so the large card i splaced landscape and scored on line 7, move the whole piece over so your score line is now on line 5 and then score line 6

Next I rounded the corners to the right hand side of the card before taking the small piece of card and scoreing it on line 1 and line 2 and rounding the right hand side corners.

The small strip is then attached to the large piece with double sided tape to form the envelope flap as in the photo above

Now the nice bits - I cut out the pieces to cover the inside and outside of the card - as I said it is all measured for me - just cut and stick in place!

Once the backing papers are on its time to add the pouch inside - how easy  - it was just a case of scoring and creasing the outer edges of one panel and securing on place with double sided tape


Finally I attached the base layer of decoupage to the front flap - taking care not to attach anywhere else or the card wouldnt open

After all the decoupage was added I stuck a gift tag to the scrap card and cut out, then punched a single hole and used coloured fibres to finish!

The whole card was highlighted with glossy accents and glitter to finish

What a super card and pressie in one - wouldnt you agree???

Thanks for looking - see you again soon





Sunday, 23 October 2011

Flowers & Lace

An 8x8 card blank was used on this sheet.

The sheet shows a collection of pretty lilac and purple flowers hiding among the leaves...



I cut out the layers and built them up using stick pads

ON the lace surround I used lilac pearlidoodles in the centre of the flowers as with that stuff you simply add your blob to suit and when you lift the bottle up it forms a peek which stays in place even when dry!!!

Once it was all finished and dry I did the 1st coat of Crafters Companion varnish spray - love the spray but after giving the card at least 7 coats I was almost out of the spray!!!

Blue Pansy

Almost to the end of these 8x8 cards now

This pretty card is suitable for most occasions however when making up the card I went with a Happy Birthday sentiment as we all need these cards all the time.

So as with the last lot of cards - the base layer was attached to an 8x8 card blank


The corners were rounded on the base image as well as the card blank.

The top layers of decoupage were carefully shaped then added to finish the card

Once I was happy with the card in general I decided to spray it all in crafters companion silver glitter spray = and what a result!!

Pinky Purple Pansy

Hope you wont get too bored with these cards - basically as they are all pretty much alike!

Another previous purchase from Crafts You Print - which I dont have any information on for you - Im so sorry!



Anyway - this lovely pansy sheet was added to my 8x8" card blank - having first rounded the corners on the card blank and the sheet....

After cutting and building up most of the decoupage just leaving the top layers which I shaped before adding!

I chose some small but pretty cerise coloured pearls which were added around the lace edging for a great effect.

Once the pearls were dry I sprayed the entire card with Crafters Companion irredescent glitter spray to give it a WOW factor


Saturday, 22 October 2011

Glittered Roses

So tell me in all honesty who would NOT like to recieve this stunning card??

It is so different - so pretty - so suitable for any occassion which is why I didnt actually add a sentiment to it at the time....

Another sheet from Crafts You Print that I have no maker or number of - sorry!



But I added the base sheet to an 8x8 card and added the small amount of 3d decouage

I decided not to stick the butterflies wings down as they look so pretty being free...

The roses and butterfly were all edged using a Sakura Quickie Glue Pen and sprinkled with a generous helping of Glamour Dust

3 large lilac pearl gems were attached to the top right corner and 4 small gems filled in the design at the centre top of the sheet!!

All in all a very pretty card for all ages and occasions - I am even thinking of framing this as it would look stunning....

Tell me what you think to it now please...